VIGO PHOTONICS · SMART TAIWAN
PVIA-4TE-10 infrared detector
PVIA-4TE-10-1x1-TO8-wZnSeAR-36
A four-stage TE-cooled InAsSb superlattice photovoltaic detector with optical immersion and an AR-coated wedged ZnSe window. Evaluate this configuration for longer-wavelength spectroscopy, FTIR and laser measurement designs.

Specifications and configuration
| Material / detection | InAsSb superlattice / photovoltaic |
|---|---|
| Typical spectral range | 1.8–11.3 μm (10% response) |
| Peak wavelength | 6.7 μm (typ.) |
| Optical area | 1 × 1 mm |
| Cooling / chip temperature | 4TE / approximately 200 K |
| Package / acceptance angle | TO8 / approximately 36° |
| Typical D* | 1.0 × 10¹⁰ cm·Hz½/W (λpeak, 20 kHz) |
| Typical current responsivity | 0.55 A/W (λpeak) |
| Typical time constant | 3 ns |
Tamb = 293 K; Tchip = 200 K; Vb = 0 V.
Typical values are not guaranteed limits. Refer to the original English datasheet for full test conditions, minimum / maximum values and operating limits. D* figures measured at different frequencies are not directly comparable.
Manufacturer spectral response

Selection and integration considerations
- Check responsivity at the operating wavelength rather than treating the cut-off as uniform sensitivity.
- For CO₂ laser measurements, confirm incident power, beam size, attenuation and linearity limits.
- Select the amplifier, TEC controller, heatsink and optical interface together; this is not a complete gas analyser.
Original English documents and resources
Start with your measurement requirements
Share the model or application, wavelength, signal bandwidth, quantity and desired schedule. Unknown items can be discussed during selection.
Submit a VIGO inquiry